Based on the Duet 3 by Think3dPrint3d and Esher3d. This reproduction/modification is not endorsed or supported in any way by Think3dPrint3d or Escher3d
- ARM Cortex M0+ processor running at 48MHz
- One TMC2209 stepper driver with stall detection and stealthChop. Maximum output current 1.6A peak, 1.1A RMS
- One medium current output intended for extruder heater, maximum current 5A
- One 3-wire 12V fan output (also accept 2-wire fan)
- One 4-wire 12V fan output (also accepts 2-wire fan)
- Two thermistor or PT1000 inputs. One uses a 16-bit ADC for high resolution reading of PT1000 sensors.
- One 3-pin filament monitor connector
- One Z-probe connector
- Two push buttons and indication LEDs
- 12 to 32V power input
- On-board 12V, 5V and 3.3V regulators
- CAN-FD interconnect to main controller board and other Toolboards or expansion boards
